Idex MICROPUMP EAGLEDRIVE EMSN Series User Manual

DOC No: PN 86880 REV A
11
LOCATION
Pump head cannot support the weight of the motor. Ensure
the motor is adequately supported by the foundation and/or
mounting bracket.
The foundation must be capable of supporting the combined weight
of the pump and motor and provide a rigid support.
The product should be located with the inlet below or even with the liquid level of
the uid supply. The product can be mounted in any position. Ensure that there is
adequate space for operation, inspection and maintenance.
BULKHEAD MOUNTING
(DEELE MODEL)
If mounting the pump/EagleDrive assembly through a bulkhead, insert the
bulkhead o-ring (ITEM 1) into the groove in the face of the housing (ITEM 3).
Position the adaptor ange (ITEM 2) through the bulkhead hole so that it does
not interfere with the sealing of the bulkhead hole. Secure the pump/EagleDrive
assembly using four screws, nuts, and washers as needed. Tighten screws evenly
and in an alternating pattern.
ITEM 1: o-ring 2-040 described below is necessary to ensure
bulkhead is sealed.

Idex MICROPUMP EAGLEDRIVE EMSN Series Specifications

General

Brand	Idex
Model	MICROPUMP EAGLEDRIVE EMSN Series
Category	Engine
Language	English