AmpliTube X-SPACE
Front Panel Overview
4
5. PRE-DELAY knob
The PRE-DELAY knob controls mainly the pre-delay amount.
6. COLOR knob
The COLOR knob controls the frequency response of the reverb.
7. MOD knob
The MODULATION knob controls the amount of modulation happening in the reverb.
8. MIX knob
The MIX knob controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the
signal is fully wet. At around 85% the dry and wet signal have the same level.
9. A, B & C LEDs
Green if preset is active.
Amber if preset has been edited.
Blinking amber when browsing among banks.
Off if bypassed.
10. A, B & C footswitches
Press to engage or bypass preset of the current bank.
Hold while preset is ON to access the X-MODE for selected model.
Hold while preset is OFF to activate that preset temporary while the footswitch is held down.
Press A+B to select a lower bank.
Press B+C to select a higher bank.
To Next Page
Loading...
Need help?
General
