1
Open the door fully
and hold the two
door hinges .
90°
2
Lift and turn the lev-
ers on the two hinges.
A
A
3
Close the oven door
to the first open posi-
tion (approx. 45°).
Then pull forward
and remove it from its
seat.
45°
4
Hold the door strip
on the upper side of
the oven door on
both sides and press
this inwards in order
to loosen the seal.
Then pull the door
strip upwards and
off.
5
Hold the glass panel
on their upper side
and it up and out of
its retainer.
Clean the glass oven door with water and
soap. Dry it carefully.
Inserting the glass panels and door
Inserting the panel and the door:
1. Slide the glass door panel into the retainer
from above at an angle and then lower the
panel.
2. Hold the door strip on both sides, align it
with the inner edge of the door and press
the door strip into the upper edge of the
door.
3. Open the door as far as it will go.
4. Fold the clamp levers on both door hinges
down into their original position.
5. Close the oven door.
Side rails
To clean the side walls of the oven cavity, re-
move the side rails.
1
Pull the rails away
from the oven wall at
the front.
2
2
1
Then unhook the rails
at the back.
To put the side rails back, follow the instruction
in reverse.
Important! The rounded ends of the guide
bars must point to the front.
Changing the oven lamp and cleaning the
glass cover
Warning! Before you change the oven
lamp (refer to "Product description"),
switch off the appliance and disconnect it from
the electrical supply.
ENGLISH 12
To Next Page
Loading...
Need help?
General