Removing the residues and stubborn
residues:
1. Food containing sugar, plastics, tin foil
residues should be removed at once,
best tool for cleaning glass surface is a
scraper (not included with the appli-
ance). Place a scraper on the glass ce-
ramic surface at an angle and remove
residues by sliding the blade over the
surface. Wipe the appliance with a
damp cloth and a little washing up liq-
uid. Finally, rub the appliance dry using
a clean cloth.
2. Limescale rings, water rings, fat
splashes, shiny metallic discolorations
should be removed after the appliance
has cooled down using cleaner for
glass ceramic or stainless steel.
What to do if…
Problem Possible cause Remedy
The appliance cannot be
switched on or is not operat-
ing.
More than 10 seconds have
passed since the appliance
was switched on.
Switch the appliance on
again.
The child safety device is
switched on
.
Deactivate child safety de-
vice (See the section “Child
safety device” ).
Several sensor fields were
touched at the same time.
Only touch one sensor field.
Acoustic signal sounds, ap-
pliance switches off.
One or more sensor fields
have been covered for lon-
ger than 10 seconds.
Uncover sensor field.
Display is switching between
two heat settings.
Power management is re-
ducing the power of this
cooking zone.
See the section "Switching
the power function on and
off".
lights up on the heat set-
ting display.
Unsuitable cookware. Use suitable cookware.
No cookware on the cook-
ing zone.
Place cookware on the
cooking zone.
The diameter of the bottom
of the cookware is too small
for the cooking zone.
Move onto a smaller cook-
ing zone.
symbol plus a number
appears on the heat setting
display.
Electronics fault. Disconnect the appliance
from the electrical supply for
a few minutes (Take the fuse
out of the house’s electric
system) If after switching on
again,
is displayed
again, call the after sales
service.
ENGLISH 10
To Next Page
Loading...
Need help?
General