Problem Possible cause Possible solution
The salt indicator con-
tinues to stay on after
the replenishment of
the salt container.
This can occur when you are
using salt that needs more time
to dissolve.
There is no unwanted effect on
the performance of the appli-
ance.
If after 3 or 4 programmes, the
salt indicator continues to stay
on, contact the service.
After the checks are completed, activate the
appliance. The programme continues from
the point of interruption.
If the problem occurs again, contact the
service.
If the display shows other alarm codes, con-
tact the service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on glasses
and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector to
a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature drying
phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
Refer to ‘HINTS AND TIPS’ for other
possible causes.
Technical information
Dimensions Width / Height / Depth (mm) 596 / 818 - 898 / 555
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2)
max. 60 °C
Capacity Place settings 12
Power consumption Left-on mode 0.99 W
Off-mode 0.10 W
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water
supply to decrease energy consumption.
ENGLISH 16
To Next Page
Loading...
Need help?
General
