1
2 3
18
ENGLISH
Blind stitch
Choose the blind stitch by turning stitch selector dial to either L or M. The
thread tension should be from 1-4. Make sure the presser foot is properly
attached (page 21).
1. Move the needle upwards by turning the hand wheel towards you. Fold
the fabric as shown in picture. Lift up the presser foot and feed the fabric
underneath. Turn the hand wheel towards you to move the needle down
so that the needle just passes through left of the folded portion of the
fabric. Lower the presser foot. Make sure that the top thread and bob-
bin thread are pulled towards the back of the machine under the presser
foot.
2. Press the foot control carefully and start sewing.
3. When you have nished, lift the fabric and pull it about 15 cm back-
wards. Cut the threads with the thread cutter, leaving them the right
length for when you start sewing the next seam.
TIP! Try sewing on a scrap of fabric rst to adjust any settings if necessary
before using the “proper” fabric.
Foot Stich Thread
tension
To Next Page
Need help?
General
