FACTORY RESET YOUR DEVICES
For light sources:
Toggle the main switch 6 times.
For remote control:
Press the pairing button 4 times within 5
seconds.
SYNCHRONIZING
If your light source becomes
unsynchronized, press and hold the ON/OFF
button for at least 3 seconds to return
the light source to its default setting (100%
brightness, 2700K).
CHANGING THE BATTERY
When the remote control is used regularly
and as intended, the batteries will last for
approximately 2 years.
When it’s time to replace the battery, a red
LED indicator will ash when you press any
button on the remote control.
Open the battery lid and replace the battery
with a new CR2032 battery.
CAUTION!
Risk of explosion if battery is replaced by
an incorrect type. Dispose of used batteries
according to the instructions.
IMPORTANT!
— The remote control is for indoor use only
and can be used in temperatures ranging
from 0ºC to 40 ºC.
— Do not leave the remote control in direct
sunlight or near any heat source, as it
may overheat.
— The range between the remote control
and the receiver are measured in open
air.
— Different building materials and
placement of the units can affect the
wireless connectivity range.
5
To Next Page
Loading...
Need help?
General
