13
ASSEMBLY
• Loosen the fastening screw (3) on the handle (1) and remove it.
• Connect the handle (1) to the body of the appliance, taking care to t it correctly.
• Insert the fastening screw (3) and tighten it clockwise [Fig. B1].
• The release button on the handle (1A) clicks into place when it is fastened correctly [Fig. B1].
• Select the hard floor brush (13) or the required accessory (16-17-18-19 for articles 8662 and
8668 only) and connect this to the suction connection.
ACCESSORIES
Your appliance comes with the following accessories:
• Hard floor brush (13): The hard oor brush (13) is suitable for all surfaces
• Wooden floor brush (18 - where present): Special brush for cleaning wooden ooring
• Shoulder strap (15 - where present): Latched to the shoulder strap eyelets (5) using the
corresponding clips (15A), it can be transported easily when using the various accessories [Fig.
H1 - H2]
• Crevice nozzle (16 - where present): To clean in corners and crevices, e.g. radiators, skirting
boards, blinds, awnings.
• Multi-purpose nozzle (17 - where present): For cleaning sofas, armchairs, upholstered chairs and
curtains.
• Flexible pipe (19 - where present): Connected to the stick vacuum cleaner it helps reach areas
that are difcult to clean
USE
• Turn the upper cable hook downwards (1A) [Fig. C1].
• Fully unwind the power cable (2).
WARNING! DO NOT use this appliance if there are visible
signs of damage.
WARNING! DO NOT use this appliance to vacuum:
•
burning ashes, cigarette butts, etc.;
• liquids, such as carpet cleaners;
• sharp or hard objects, such as nails or large shards of glass;
• fine powder, such as cement;
• toner powder (for laser printers, copy machines, etc.).
WARNING! Unwind the supply cord completely to prevent
hazardous overheating.
To Next Page
Loading...
Need help?
General
