Indesit IDS 105 User Manual

GB
12
Troubleshooting
Whenevertheappliancefailstowork,checkforasolutionfromthefollowinglistbeforecallingforAFTERSALES
SERVICE.
* Only available in selected models.
Problem: Possible causes / Solutions:
The dishwasher does not start or cannot
be controlled
• SwitchofftheappliancebypressingtheON/OFFbutton,switchitbackonafter
approximately one minute and reset the program.
• Theappliancehasnotbeenpluggedinproperly.
• Thedishwasherdoorhasnotbeenshutproperly.
The door won’t close • Thelockwasreleased.Stronglypushthedooruntila“clacking”noiseisheard.
No water drains out from the dishwasher. • Thedishwashercyclehasnotyetnished.
• Thewaterinlethoseisbent(see Installation).
• Thedrainductisblocked.
• Thelteriscloggedupwithfoodresidues.
The dishwasher makes excessive noise. • Thedishesarerattlingagainsteachotheroragainstthesprayerarms.
• Anexcessiveamountoffoamhasbeenproduced:thedetergenthasnotbeen
measured out correctly or it is not suitable for use in dishwashers (see Start-up
and use).
The dishes and glasses are covered in a
white lm or limescale deposits.
• Theleveloftherenedsaltisloworthedosagesettingisnotsuitedtothe
hardness of the water (see Rinse aid and salt).
• Thelidonthesaltdispenserisnotclosedproperly.
• Therinseaidhasbeenuseduporthedosageistoolow.
The dishes and glasses are streaked or
have a bluish tinge.
• Therinseaiddosageistoohigh.
The crockery has not been dried
properly.
• Awashcyclewithoutadryingprogramhasbeenselected.
• Therinseaidhasbeenuseduporthedosageistoolow(see Rinse aid and
salt).
• Therinseaiddispensersettingisnotsuitable.
• Thecrockeryismadefromnon-stickmaterialorplastic.
The dishes are not clean. • Theracksareoverloaded(seeLoadingtheracks).
• Thecrockeryhasnotbeenarrangedwell.
• Thesprayerarmscannotmovefreely.
• Thewashcycleistoogentle(see Wash cycles).
• Anexcessiveamountoffoamhasbeenproduced:thedetergenthasnotbeen
measured out correctly or it is not suitable for use in dishwashers (see Start-up
and use).
• Thelidontherinseaidcompartmenthasnotbeenshutcorrectly.
• Thelterisdirtyorblocked(seeCareandmaintenance).
• Therenedsaltlevelislow(seeRinseaidandsalt).
The dishwasher does not take any water
in - Tap shut-off alarm
(several short beeps are emitted*)
(theDryingandEndindicatorlightsash).
• Thereisnowaterinthemainssupply.
• Thewaterinlethoseisbent(seeInstallation).
• Turnonthetapandtheappliancewillstartafterafewminutes.
• Theappliancelockhasbeenactivatedbecausenoactionwastakenwhenthe
beeps* sounded. Switch off the appliance using the ON/OFF button, turn on the
tap and switch the appliance back on after 20 seconds by pressing the same
button. Re-program the appliance and restart the wash cycle.
Water inlet hose alarm / Water inlet lter
blocked
(the Washing, Drying and End indicator
lightsashes).
• SwitchofftheappliancebypressingtheON/OFFbutton.Shutoffthewatertap
toeliminatetheriskofoodingandremovetheplugfromtheelectricalsocket.
 Makesurethewaterinletlterhasnotbecomeblockedbyimpurities(see“Care
andmaintenance”chapter).

Indesit IDS 105 Specifications

General

Style	Free-Standing
Color	White
Load Capacity	12 Place Settings
Number of Cycles	5
Cycle Selections	Rinse Only
Options/Settings	13
Drying Type	Residual
Temperature Options	45-70°C
Noise level	53 dB
Special Features	Child Lock
Energy Class	A
Annual Energy Consumption	-
Energy Consumption Per Cycle	-
Annual Water Consumption	-
Water Consumption Per Cycle	10 L
Voltage	-
Frequency	-
Current	-

Weight and Dimensions

Depth	600 mm
Height	850 mm
Width	450 mm
Net Weight	-