Operation30
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at
either the top or bottom. It occurs when the projector is not perpendicular to the
screen.
To correct this, besides adjusting the height of the projector, you will need to
manually correct it following ONE of these steps.
• Press / on the projector or remote
control to display the Keystone correction
page. Press to correct keystoning at the
top of the image. Press to correct
keystoning at the bottom of the image.
• Press Menu/Exit on the projector or remote
control. Go to the
DISPLAY > Keystone and
adjust the values by pressing or on
the projector or remote control.
Keystone
BackMENU
Press /.
Press /.
To Next Page
Loading...
Need help?
General