Operation 41
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker.
Be sure you have made a correct connection to the projector audio input. See
"Connection" on page 13 for how the audio input is connected.
Muting the sound
To temporarily turn off the sound,
1. Press Menu/Exit and then press / until the SYSTEM SETUP: Advanced
menu is highlighted.
2. Press to highlight Audio Settings and press Mode/Enter on the projector
or remote control. The Audio Settings page displays.
3. Highlight Mute and press / to select On.
Adjusting the sound level
To adjust the sound level,
1. Repeat steps 1-2 above.
2. Press to highlight Volume and press / to select a desired sound level.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences.
The following settings do not affect the projection settings, operation, or
performance.
• Menu Display Time in the SYSTEM SETUP: Advanced > Menu Settings
menu sets the length of time the OSD will remain active after your last button
press. The time length ranges from 5 to 30 seconds in 5-second increments.
Use / to select a suitable time.
• Menu Position in the SYSTEM SETUP: Advanced > Menu Settings menu
sets the OSD position in five locations. Use / to select a preferred position.
• Language in the SYSTEM SETUP: Basic menu sets your familiar language for
the On-Screen (OSD) Menus. Use / to select your language.
• Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo
screen to be displayed during projector start-up. Use / to select a screen.
To Next Page
Loading...
Need help?
General