8
NS-CF30SS9
www.insigniaproducts.com
• Locate the refrigerator away from direct sunlight and sources of heat (stove,
heater, radiator, and so on). Direct sunlight may affect the acrylic coating
and heat sources may increase electrical consumption. Ambient
temperature below 50°F (10°C) or above 85°F (29.4°C) will hinder the
performance of this refrigerator. This refrigerator can be placed in a garage
as long as the ambient temperature in the garage is between 50°F (10°C)
and 85°F (29.4°C). It is not designed for use outside.
• Avoid locating the refrigerator in moist areas.
• This refrigerator can be placed on carpet, but care should be taken not to
damage the carpet when moving the refrigerator.
Leveling your refrigerator
• It is very important for the refrigerator to be level in order to function
properly. If the refrigerator is not leveled during installation, the doors may
not close or seal properly, causing cooling, frost, or moisture problems.
• To level your refrigerator, you may either turn the leveling foot clockwise to
raise that side of the refrigerator or turn it counter-clockwise to lower that
side.
Providing proper ventilation
Place the refrigerator at lease 5 in. (12.7 cm) from the wall to ensure proper airflow
to the compressor. Do not place the refrigerator near any heat sources, such as a
heater or stove, as this may put strain on the compressor.
Providing a proper power supply
Check your local power source. This refrigerator requires a 110V-120V, 60Hz power
supply.
Use a receptacle that accepts the grounding prong. The power cord is equipped
with a 3-prong (grounding) plug which goes into a standard 3-prong (grounding)
wall outlet to minimize the possibility of electric shock.
Note: Having someone push against the top of the refrigerator helps to take
some weight off the leveling foot, making it easier to adjust.
Notes:
• The refrigerator should always be plugged into its own individual electrical
outlet which has a voltage rating that matches the rating plate.
• Never unplug your refrigerator by pulling on the power cord. Always grip the
plug firmly and pull straight out from the outlet.