9
4.3 Cubic Foot Compact Refrigerator
www.insigniaproducts.com
Setting the thermostat
1 The first time you turn the refrigerator on, adjust the thermostat to “7” and run for at
least two hours before putting food in.
2 After it is fully cooled, test it and adjust towards “4” to make less cool, to best suit your
needs. The “4” setting should be appropriate for home or office refrigerator use.
Using the freezer compartment
The freezer compartment is designed for the long-term storage of frozen foods.
The storage life of frozen foods varies and the recommended storage time should not be
exceeded.
Place frozen food into the freezer as quickly as possible after purchase. If there are
instructions on the packet, carefully follow these instructions regarding storage times.
Making ice
1 Set the thermostat to “7”.
2 Fill the ice cube tray (2/3 capacity) with cold water and place the tray on the bottom
of the freezer compartment to freeze properly.
3 When the water in the ice cube tray has hardened, remove the ice tray from the
freezer, then twist slightly to eject the ice cubes from the tray.
4 Re-set the thermostat to “4” when you are done making ice.
Notes:
• Turning the thermostat to the “0” position stops the cooling cycle but does not
shut off the power to the refrigerator.
• If the refrigerator is unplugged or loses power, you must wait three to five minutes
before restarting it. If you attempt to restart before this time delay, the refrigerator
will not start.
• Large amounts of food will lower the cooling efficiency of the refrigerator.
• If you choose to change the thermostat setting, adjust it by one increment at a
time. Allow several hours for the temperature to stabilize between adjustments.
To Next Page
Loading...
Need help?
General
