Insignia NS-FDRE67WH8A-C User Manual

17
6.7 Cu. Ft. Front-Load Electric and Gas Dryers
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
Installing your dryer
Tools you will need
Before you start
Before you start installing your dryer, make sure that:
• The location you selected has a grounded electrical outlet. See Grounding requirements
on page 16.
• For U.S. models, you have the correct type power cord (not included). See Electric requirements—U.S. only
on
page 15
.
Note: For Canadian models, the power cord comes pre-installed.
• Your exhaust ducting (not included) is made of rigid metal or flexible stiff-walled metal. See Ducting
requirements on page 12.
• GAS LINES (if you are installing a gas dryer) must meet all national and local codes.
Step-by-Step instructions
Step 1: Make sure that the floor is a solid, level surface
• Use a level to make sure that the floor where you are installing your dryer is level. This helps minimize vibration,
noise, and unwanted movement.
Step 2: Move your dryer to the location you selected
• Move your dryer to the location you selected, but do not push your dryer all the way back into the location. You
need to connect the power cord and ducting before you move your dryer into its final position.
Important
We recommend that you use a qualified installer to install your dryer.
Tip
For information about space requirements for a side-by-side installation, see
Installing your dryer and washer side-by-side
on page 10.
Pliers
Phillips
screwdriver
Level
Duct tape
Adjustable
wrench that
opens to 1"
(25 mm)
Cutting knife
Flat-head
screwdriver
Pipe wrench
NS-FDRE67WH8A-C_NS-FDRE67WH8A_NS-FDRG67WH8A_17-0815_MAN_V5_EN.fm Page 17 Wednesday, November 15, 2017 12:25 PM

Insignia NS-FDRE67WH8A-C Specifications

General

Brand	Insignia
Model	NS-FDRE67WH8A-C
Category	Dryer
Language	English