10
Insignia Ceramic Tower Heater
www.insigniaproducts.com
Safety features
The heater is equipped with double over-heating protection, which
causes the unit to stop operating in the event that the internal
temperature exceeds the normal operating temperature. It also includes
tip-over protection, which turns the heater off in case it is tipped over.
If the heater shuts down:
1 Turn off and unplug the heater.
2 Put the heater in the upright position, if necessary.
3 Wait for at least 10 minutes until the heater cools.
4 Plug the heater into the power outlet and then turn it on. The heater
resumes its normal operation.
Troubleshooting
Caution
Do not try to repair your heater yourself. Doing so invalidates the
warranty.
Problem Possible cause Possible solution
Your heater shuts off
unexpectedly or fails
to operate
There is no power. Make sure that the heater is plugged in and that the electrical outlet
is working.
The set temperature is lower
than the current room
temperature.
Set the desired temperature higher than the current temperature to
restart the heater.
Room temperature has
reached the temperature set
on the temperature control
dial.
• This is normal. The heater restarts when room temperature is lower
than the set temperature.
• Adjust the temperature control dial setting if it's not set to your
desired temperature.
One of the safety protection
devices was activated to
prevent overheating.
1. Place the heater in an upright position.
2. Check for any obstructions. If you find an obstruction, turn the
heater off.
3. Unplug the heater and wait at least 10 minutes for it to cool down.
4. Carefully remove the obstruction. Plug the heater in and restart it
as described in “Using your heater” on page 8.
5. If you still notice the same problem, remove the plug from the wall
and have the heater checked by an authorized service person.
The room is not warm
enough
The room is too large or a
window is open.
• Turn on the main heat source for the room.
• Use more portable heaters.
•Close the window.
The temperature is set too low. • Increase the temperature setting.
The power setting is too low. • Select a higher power setting.
NS-HTTCWH6_15-0380_MAN_V1_ENG.fm Page 10 Thursday, May 14, 2015 8:56 AM
To Next Page
Loading...
Need help?
General
