Intel 80287 User Manual

POINTER TO
INTERRUPT HANDLER
FOR:
INTERRUPT 255
INTERRUPT 254
INTERRUPT 253
INTERRUPT 1
INTERRUPT 0
POINTER
POINTER
POINTER
POINTER
POINTER
REAL ADDRESS MODE
..
PHYSICAL
ADDRESS
1020
1016
1012
4
0
1
0
•
19
I
. . . .
. .
01
VECTOR 101 oj
10
9 2 1 0
G3010a
Figure 5-3. Interrupt Vector Table for Real Address Mode
Table 5-1.
Interrupt Processing Order
Order
Interrupt
1.
Instruction exception
2.
Single step
3.
NMI
4.
Processor extension segment overrun
5.
INTR
The Interrupt Vector Table consists of as many as 256 consecutive entries, each four bytes long. Each
entry defines the address of a service routine to be associated \vith the correspondingly numbered
interrupt vector code. Within each entry, an address
is specified by a full 32-bit pointer that consists
of a 16-bit offset and a 16-bit segment selector. Interrupts
0-31 are reserved by Intel.
In Real Address Mode, the interrupt table can be accessed directly
at physical memory location
o through 1023. In the protected virtual address mode, however, the interrupt vector table has no fixed
physical address and cannot be directly accessed. Therefore,
Real Address mode programs that directly
manipulate the interrupt vector table will not work
in the protected virtual address mode.
5.2.1.1 INTERRUPT PRIORITIES
When simultaneous interrupt requests occur, they are processed in a fixed order as shown in table 5-1.
Interrupt processing involves saving the flags, the return address, and setting CS:IP to point at the first
instruction of the interrupt handler.
If other interrupts remain enabled, they are processed before the
first instruction of the current interrupt handler
is executed. The last interrupt processed is therefore
the first one serviced.
5-4
pcjs.org

Intel 80287 Specifications

General

Brand	Intel
Model	80287
Category	Computer Hardware
Language	English