Embedded Intel® Atom Processor D2700 with Intel® NM10 Express Chipset
78
5.2 Front-panel Power LED Blink Codes
panel power LED to blink an error message describing the problem (see Table 41).
Table 41. Front-panel Power LED Blink Codes
Off when the update begins, then on for
0.5 seconds, then off for 0.5 seconds. The
pattern repeats until the BIOS update is
complete.
On-off (1.0 second each) two times, then
2.5-second pause (off), entire pattern repeats
(blink and pause) until the system is powered
off.
When no VGA option ROM is
found.
On-off (1.0 second each) three times, then
2.5-second pause (off), entire pattern repeats
(blinks and pause) until the system is powered
off.
Each beep will be accompanied by the following
blink pattern: .25 seconds on, .25 seconds off,
.25 seconds on, .25 seconds off. This will result
in a total of 16 blinks.
Note: Disabled per default BIOS setup option.
5.3 BIOS Error Messages
Whenever a recoverable error occurs during POST, the BIOS displays an error message
describing the problem. Table 42 lists the error messages and provides a brief
description of each.
Table 42. BIOS Error Messages
The battery may be losing power. Replace the battery soon.
The CMOS checksum is incorrect. CMOS memory may have been
corrupted. Run Setup to reset values.
Memory size has decreased since the last boot. If no memory
was removed, then memory may be bad.
System did not find a device to boot.
Download from Www.Somanuals.com. All Manuals Search And Download.
To Next Page
Loading...
Need help?
General
