Intel Desktop Board D865GSA Product Guide
14
Main Memory
NOTE
To be fully compliant with all applicable Intel
®
SDRAM memory specifications, the board should
be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If your
memory modules do not support SPD, you will see a notification to this effect on the screen at
power up. The BIOS will attempt to configure the memory controller for normal operation.
The desktop board supports system memory as defined below:
• Two dual channel 184-pin Double Data Rate (DDR) SDRAM Dual Inline Memory Module
(DIMM) connectors with gold-plated contacts.
• Memory speeds as defined in Table 4.
Table 4. Desktop Board D865GSA Memory Speeds
Memory Speed Front Side Bus Frequency (MHz) Memory Speed Outcome (MHz)
DDR400 800 400
800 320 DDR333
533 333
DDR266 533 266
• Support for:
⎯ Unbuffered, non-registered DIMMs
⎯ Serial Presence Detect (SPD) memory only
⎯ Suspend to RAM (STR), S3 ACPI state
⎯ Non-ECC DDR
⎯ 2.5 V memory
⎯ Memory configuration listed below:
Up to 1.0 GB utilizing 256 Mb technology
Up to 2.0 GB utilizing 512 Mb technology
Related Links:
Go to the following links or pages for more information about:
• The latest list of tested memory, http://support.intel.com/support/motherboards/desktop/
• SDRAM specifications, http://www.intel.com/technology/memory/
• Installing memory, page 31 in Chapter 2
To Next Page
Loading...
Need help?
General
