2 / 10 P/N 466-5437 • REV A • 16OCT18
There are several ways to navigate to the Main screen (Table 1
describes its features):
By pressing the Close icon. Depending on the
current screen, the user may need to press the Close
icon multiple times.
After a period of inactivity, the Main screen will return
(unless you set a blank screen as your default screen
saver).
If an alarm occurs, the screen will automatically return to
the Main screen.
Note: The touch screen will automatically blank at 2:00 am daily for
60 minutes. Touch the screen to reactivate.
Note: The Main screen factory default can be changed the after
your security provider’s installation has been completed.
Table 1: Main Screen
Access the emergency screen to select the
appropriate emergency icon (Panic, Police, or
Fire).
Depicts the status of the AC power and battery.
Note: These icons only appear in red on the
main screen if the backup battery is not fully
charged or AC power is not working correctly.
This yellow triangle indicates faults within the
system.
This will appear on the Main screen in the event
of an alarm. Messages will also display on this
icon describing what caused the alarm. Press
this icon to cancel the alarm.
* Depicts monitored door status. A green check
indicates all monitored doors are closed. A red
exclamation point indicates one or more doors
are open.
* Depicts monitored window status. A green
check indicates all monitored windows are
closed. A red exclamation point indicates one
or more windows are open.
* Depicts motions sensor status. A green check
indicates no recent motion detected. A red
exclamation point indicates motion was
detected in the last 10 minutes.
* Depicts other changes to protected property in
your system. A green check indicates all
sensors are closed and no activity since you
last checked. A red exclamation point indicates
either a sensor is tripped, or there is
unacknowledged activity.
* Note: Pressing the above sensor icons will open a new screen to
provide more detail. These icons may contain the text “N/A”
which indicates your system is not configured to support
this feature. Consult your dealer for additional information.
Press this icon to access the Arming Screen.
One of these icons will display depending on
your arming level. Press to turn off
intrusion/burglary protection for your system.
Only intrusion/burglary sensors are disarmed.
Environmental sensors, such as smoke and
carbon monoxide detectors, stay active at all
times. Enter your code in the keypad screen that
appears. If you enter an incorrect code, press
the Clear icon and enter the correct code.
Press to access the Status & Settings screen.
Arming Screen
When you touch the PRESS TO ARM icon on the Main
screen, the Arm screen appears with the following arming
choices:
Figure 2: Arming Screen
Note: Depending on configuration by your security provider, your
ARM screen may have three buttons displayed instead of
two.
Table 2: Arming Screen Icons
ARM STAY (Doors
and Windows Only)
This icon activates perimeter sensor only.
This icon activates all sensors.
This icon opens optional arming choices
“Silent Exit” and “Entry Delay”.
Note: You will see icons at the top of the screen depicting the
current state of your installed sensors.
To Next Page
Loading...
Need help?
General
