(93IO) “ISO” BOAT W/O MOTOR MOUNTING (TYPE I) ENGLISH 4.875” X 7.25” 04/08/2020
SAVE THESE INSTRUCTIONS
Page 6
93A
Inflating Instructions
Before starting, locate a clean area free of stones or other sharp objects. Unroll the
boat so it is laid out flat, and locate your pump.
Use a hand or foot operated air pump to inflate the boat. Do not use high-pressure air
compressors. Adults should inflate the chambers following the numerical sequence marked
on the valves. It is very important to follow the numerical sequence; failure to do so will result
in an improperly inflated boat. Fill each chamber until it is stiff to the touch but NOT hard.
Use the enclosed ruler to check the main chamber for proper inflation by leveling it with the
gauges printed on the boat. DO NOT OVER INFLATE. Fill with cold air only.
IMPORTANT:
Air temperature and weather condition do affect the internal air pressure of
inflatable products. In cold weather the product will lose some pressure due to the fact that
the air will contract. If this occurs, you may want to add a little air to the product. However, in
hot weather, the air will expand. You must let some air out to prevent the product from failing
due to overpressure.
How to Use Boston Valve:
1. Double valve cap (valve lets air in, not out).
2. Quick deflation cap.
3. Unscrew Double valve cap.
4. Insert output end of air pump into valve and fill. Do not over inflate or use high pressure
compressor.
5. To deflate: Unscrew quick-deflation cap.
CAUTION:
Double valve does not operate
when this cap is off. Do not unscrew this cap while boat or inflatable is in water.
Fishing Rod Holder Use
(Certain Models):
1. Slide the end cap over the end of the
fishing rod.
2. Insert the fishing pole into the holder.
Fishing Rod Holder
Fishing Rod
Holder
End Cap
Fishing
Rod
1
2
3
4
5
To Next Page
Loading...
Need help?
General