345
A
SAVE THESE INSTRUCTIONS
(345IO) SAND FILTER PUMP COMBO ENGLISH 7.5” X 10.3” PANTONE 295U 04/10/2022
English
Page 6
The strainer grid prevents large objects from jamming and/or damaging the filter pump. If
your pool has an inflatable top ring, install the strainer, nozzle and plunger valve before
inflating the pool liner top ring. The part numbers here onward refer to the parts depicted
in the Parts List section of this manual. To install, do the following:
1.
In a counter-clockwise motion unscrew
plunger valve union from the threaded strainer
connector
(26)
(see drawing 1)
. Be careful not
to lose the step rubber washer
(23)
. Place the
plunger valve on the ground in a safe place.
2.
In a counter-clockwise motion unscrew the
strainer nut
(24)
from the threaded connector
(26)
. Leave the flat washer
(25)
on the
connector
(26)
.
3.
Install the strainer and plunger valve at the
lower position of pool outlet (marked "+").
From
the inside of the pool liner insert the connector
(26)
into one of the pre-cut holes with the
washer remaining on the connector to be
placed against the inside of the liner wall.
4.
Before assembly, lubricate the threads with a
petroleum jelly. With the flat side of the strainer
nut
(24)
facing the outside wall of the liner in
a clockwise motion screw the strainer nut
(24)
back onto the threaded connector
(26) (see
drawing 2)
.
5.
Finger tighten the strainer nut
(24)
onto the
threaded connector
(26)
.
6.
Grasp the plunger valve assembly. Make sure
the step washer
(23)
is in place.
7.
In a clockwise motion screw the plunger valve
union
back onto the threaded connector
(26)
(see drawing 3)
.
8.
In a clockwise motion turn the plunger valve
handle to close position. Ensure the plunger
valve is securely closed. This will prevent water
from flowing out during filling of the pool
(see
drawing 4)
.
POOL OUTLET
-
STRAINER & PLUNGER VALVE SETUP
(
optional
)
2
25
INSIDE
LINER WALL
24
1
23
2
1
3
1
2
4
INSIDE
LINER WALL
26 40
To Next Page
Loading...
Need help?
General
