Intex FRAME 126378NP User Manual

345
A
SAVE THESE INSTRUCTIONS
(345IO) SAND FILTER PUMP COMBO ENGLISH 7.5” X 10.3” PANTONE 295U 04/10/2022
English
Page 7
POOL INLET
-
NOZZLE & PLUNGER VALVE SETUP
(
optional
)
1.
In a counter-clockwise motion unscrew plunger
valve union from the inlet threaded air connector
(42) (see drawing 5)
. Be careful not to lose the
step rubber washer
(23)
. Place the plunger valve
on the ground in a safe place.
2.
In a counter-clockwise motion unscrew the strainer
nut
(24)
from the inlet threaded air connector
(42)
.
Leave the flat washer
(25)
on the connector
(42)
.
3.
Install the nozzle and plunger valve at the upper
position of pool inlet. From the inside of the pool
liner insert the nozzle union
(27 & 42)
into one of
the pre-cut holes with the washer remaining on the
connector to be placed against the inside of the
liner wall.
4.
Before assembly, lubricate the threads with a
petroleum jelly. Then, with the flat side of the
strainer nut
(24)
facing the outside wall of the liner
in a clockwise motion screw the strainer nut
(24)
back onto the inlet threaded air connector
(42) (see
drawing 6)
.
5.
Finger tighten the adjustable pool inlet jet nozzle
(27)
and the strainer nut
(24)
onto the inlet threaded
air connector
(42)
.
6.
Grasp the plunger valve assembly. Make sure the
step washer
(23)
is in place.
7.
Screw the air jet valve
(41)
over the inlet threaded
air connector
(42)
.
NOTE:
Make sure the air
jet valve is securely tighten and facing up. In a
clockwise motion screw the plunger valve union
back onto the inlet threaded air connector
(42) (see
drawing 7)
.
8.
In a clockwise motion turn the plunger valve
handle to close position. Ensure the plunger valve
is securely closed. This will prevent water from
flowing out during filling of the pool
(see drawing 8)
.
9.
Adjust the direction of nozzle head pointing away
from the pool outlet for a better circulation result
(see
drawing 9)
.
10.
The pool liner is now ready to fill with water.
Consult the above-ground-pool owner’s manual for
filling instructions.
NOTE:
Do not cover the air jet
valve
(41)
with the valve cap
(45)
under normal situation or when
the pump is operating. See
Troubleshooting Guide section
for more details.
5
2
1
8
INSIDE
LINER WALL
9
WATER
FLOW
POOL
6
25
42
27
INSIDE LINER
WALL
24
7
1
2
41

Intex FRAME 126378NP Specifications

General

Brand	Intex
Model	FRAME 126378NP
Category	Swimming Pool
Language	English