EasyManuals Logo
Home>Intex>Swimming Pool Heater>HT30221-2

Intex HT30221-2 User Manual

Intex HT30221-2
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
(114UK) ELECTRIC POOL HEATER ENGLISH 4.875” X 7.25” PANTONE 295U 06/23/2022
114
UK
S AVE THESE INSTRUCTIONS
Page 10
TROUBLESHOOTING GUIDE
PROBLEM CAUSE REMEDY
THE INDICATOR
DOES NOT LIGHT UP
DURING USE
1. The power cord is not
plugged in.
• Plug in the power cord.
2. The GFCI/RCD plug is not
turned on.
• Re-plug the GFCI/RCD and press the
“RESET” button.
3. The power button is not
pressed in place.
• Re-press the power button.
THE RED INDICATOR
LIGHT UP DURING
USE
1. The water temperature is
too high.
• The temperature sensor will cut off the
power of heater when the water
temperature is above approximately
95°F (35°C). It continues to work when
the water temperature drop below
approximately 82°F (28°C).
2. No water flow. • Turn on the filter pump.
3. Low water flow. • Ensure the plunger valves are opened
(if any).
• Ensure your filter cartridges are clear from
debris and dirt.
• Release all trapped air in the circulation
line.
• Check for the direction of water inlet and
water outlet hose. Reverse the hose if
necessary.
4. Heater is tilted or tipped over. • Ensure the heater is in an upright position
all the time.
THE WATER
TEMPERATURE
DOES NOT INCREASE
ALTHOUGH THE
GREEN INDICATOR IS
LIT UP
1. Pool or solar cover not been
used.
• Always use the solar cover if the pool is
not occupied.
2. The pool size or water capacity
exceeds the heater capacity.
• Increase the heating time properly.
3. The water temperature is too
low.
THE WATER
TEMPERATURE IS
TOO HIGH
1. Heating time too long. • Stop the heater and shorten the heating
time.
HOSE LEAKING
1. Hose clamps. • Tighten/reinstall hose clamps.
2. Hose seals. • Reposition/replace hose seals.
GFCI/RCD KEEPS
TRIPPING OFF
1. Product failure or electrical
circuit problem.
• Unplug the GFCI/RCD and then re-plug in
and press the “RESET” button to start
the heater. Contact Intex Service Center
if it trips off continuously.
If you continue to experience difficulty, please contact our Consumer Service
Department for assistance. See separate “Authorized Service Centers” sheet.
IMPORTANT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex HT30221-2 and is the answer not in the manual?

Intex HT30221-2 Specifications

General IconGeneral
BrandIntex
ModelHT30221-2
CategorySwimming Pool Heater
LanguageEnglish

Related product manuals