EasyManuals Logo
Home>Intex>Swimming Pool Heater>HT30221-2

Intex HT30221-2 User Manual

Intex HT30221-2
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
(114UK) ELECTRIC POOL HEATER ENGLISH 4.875” X 7.25” PANTONE 295U 06/23/2022
114
UK
S AVE THESE INSTRUCTIONS
Page 6
The appliance is ready to work under the following conditions:
FREE CHLORINE (HCIO + CIO
-
+CI
2
) up to 3 ppm
pH 6.8 - 8.0
CHLORIDES up to 3500 ppm
ISOCYANIC ACID up to 100 ppm
CALCIUM HARDNESS up to 500 ppm
BROMIDE (HBrO) up to 8 ppm
IMPORTANT: The electrical pool heater must be installed as the last piece of pool
equipment before the saltwater pool or chlorine generator system in the water return
line to the pool.
1
. Assemble the above-ground-pool (AGP) and its filter pump per installation instructions.
2. Remove the electrical pool heater and it’s accessories from the packaging.
3. Place the electrical pool heater in line after the filter pump.
4. Connect the hose (1) to the electrical pool heater inlet.
5. If your above-ground-pool is filled up with water, unscrew the strainer grids from the
strainer connectors and insert the black hat-like plugs into the strainer connectors
before electrical pool heater installation. Go to step 6 directly if your pool is empty.
6. Disconnect the water return (to the pool) hose from the filter pump connection, and
connect it to the upper electric pool heater connection with a hose clamp.
7. Connect the second hose to the lower electric pool heater connection and to the
lower pump connection. Make sure all the hose clamps (2) are tight.
8. If applicable, return strainer grids to strainer connectors inside pool after removing
black hat-like plugs that prevented water from flowing out of the pool.
9. Connect the electric pool heater to the power outlet. Test RCD as shown on following
page.
10. Turn pump on. Check water is flowing through the heater. Then turn heater on.
SET UP INSTRUCTIONS
If the heater is not in an upright position a safety switch will automatically turn
the heater off. Be sure the heater is always in an upright position while the cord
is connected to the power outlet.
Filter pump must be operating before turning on heater.
IMPORTANT
WATER TO POOL
WATER FROM POOL
FILTER PUMPELECTRIC POOL
HEATER

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex HT30221-2 and is the answer not in the manual?

Intex HT30221-2 Specifications

General IconGeneral
BrandIntex
ModelHT30221-2
CategorySwimming Pool Heater
LanguageEnglish

Related product manuals