EasyManuals Logo
Home>Intex>Swimming Pool Pump>Krystal Clear CS8231

Intex Krystal Clear CS8231 User Manual

Intex Krystal Clear CS8231
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
134A
SAVE THESE INSTRUCTIONS
(134) MODEL CS8221/CS8231 SALTWATER SYSTEM & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 11/18/2011
English
Page 11
SSEETTUUPP IINNSSTTRRUUCCTTIIOONNSS
STRAINER & PLUNGER VALVE SETUP
IMPORTANT
The Saltwater System/Filter Pump must be installed as the last piece of
pool equipment in the water return line to the pool. This location extends
the life of the titanium plates.
Strainer & Plunger Valve Setup (small AGP)
The strainer grid prevents large objects from jamming and/or damaging the
filter pump. The plunger valve assembly prevents water from flowing into the
filter pump while the filter cartridge is being placed or cleaned. If your pool
has an inflatable top ring, install the strainer, nozzle and plunger valve before
inflating the pool liner top ring. The parts numbers here onward, refer to the
parts depicted in the Parts List section of this manual. To install, do the
following:
1. Grasp the strainer and plunger valve mechanism.
2. In a counter-clockwise motion unscrew plunger valve union from the threaded
strainer connector (24). Be careful not to lose the step rubber washer (21).
3. Grasp the plunger valve assembly. Make sure the step washer (21) is in place.
Connect adaptor B (26) to plunger valve union.
4. Repeat steps 1 through 3 for nozzle and plunger valve mechanism.
5. Remove wall plug and then insert the strainer (27 & 29) into the lower position
of protruding hose connection, and the nozzle (27 & 28) into the upper position
of protruding hose connection. Adaptor B (26) fits over the strainer
connection (27) inserted into the connection.
6. Examine the plunger valve to see if the handle is pushed fully down to the "0/1"
position. If not, then grasp the handle at the top and push down turning the
handle in a clockwise direction until the plastic protruding notch anchor is in
the "0/1" position. This will prevent water from flowing out during filling.
7. The pool liner is now ready to fill with water. Consult the above-ground-pool
owner's manual for filling instructions.
19
20
21 26
27 28
19
20
21 26
27 29

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex Krystal Clear CS8231 and is the answer not in the manual?

Intex Krystal Clear CS8231 Specifications

General IconGeneral
BrandIntex
ModelKrystal Clear CS8231
CategorySwimming Pool Pump
LanguageEnglish

Related product manuals