344
PO
S AVE THESE INSTRUCTIONS
(344PO) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 07/20/2019
English
Page 15
SPA CONTROL PANEL
E: Water Jet Button
F: Bubble Button
G: Sanitizer Button
H: Heat Button
OPERATION (continued)
Water Jet Button:
Use this button to activate the jet massage system. After
30 minutes of continues use, the jet massage system will automatically turn off.
The water jet icon on the displays is green when activated. The angle of the water
jet nozzles inside the spa tub wall can be adjusted manually.
WARNING:
Do not run jet system when the cover is attached, air pressure may
accumulate inside the spa and cause irreparable damage and bodily harm.
Bubble Button:
Use this button to activate the massage system, which has a
30-minute auto-shutoff feature. The bubble icon on the displays is green when
activated.
CAUTION: Do not run Bubble system when the cover is attached, air can
accumulate inside the spa and cause irreparable damage and bodily harm.
Sanitizer Button:
Use this button to activate and set operating hours for the
sanitation system.
Heat Button:
Press this button to activate the heating system. Press
or to
set the desired water temperature. The heater will continuously heat until the water
temperature reaches the set temperature and then hold at that temperature. This
is achieved by the heater restarting automatically whenever the water temperature
drops 1.8-3.6°F (1-2°C) below the set temperature. When the fl ame icon on the
display is red, the heating system is activated. When the fl ame icon turns green, the
water is at the set temperature. The heating system is then at rest, but the fi ltration
system will continue circulating water nonstop, unless manually turned off. If the
heating system is reactivated, the fi lter pump will restart at the same time.
NOTE:
To stop the fi ltration system while the heater is at rest mode, press the fl ame
button fi rst and then the fi lter button. Pressing the heat button only while the heater is
at rest mode will turn off the heating system only and the fi ltration system will operate
for 1 more minute before it turns off or continue with the fi lter pump preset operating
hours. To turn the heater off while heating, press the fl ame button.
IMPORTANT:
The following conditions will lead to slow water heating:
• The ambient temperature is lower than 50ºF (10ºC).
• Outdoor wind speed is above 8-12 mph (3.5-5.4 m/s).
• The jet or bubble function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.
G
F
H
E
To Next Page
Loading...
Need help?
General
