23
Preparation for wrapping
Power supply
Getting started
When you see the return operation confirmation screen, touch RETURN.
The infeed pushers, lift unit and folders etc return to their original positions
and the initial screen is displayed. Pull down the seal heater guard.
Turn on the main power switch.
Check that there is nothing on the weighing table or in the wrapping area.
Parts of the machine may start to move when the main power switch is turned on.
Do not put your ngers or hand inside the machine while the main power switch is turned on.
Do not touch the main power switch with a wet hand.
The discharge heater gets very hot and may cause burns. Make sure that hands, clothes etc. do not come in contact with it.
Start up
Start up/shut down
To Next Page
Loading...
Need help?
General
