ISHIDA WM-NANO User Manual

32
Call up tray
Select a tray by pressing any of the areas marked in red in the picture to
the right, then press the DETAIL key to edit the tray.
Key in a new tray number and press PLU if you would like to create a new
tray.
Press ENTER to continue when the prompt appears.
Press CANCEL to quit.
Press "PROGRAM", go down to page 8 with the down arrow key. Press the
"TRAY" key.
Note: This step may be protected by a password. Contact you ISHIDA agent.
Mode change
Each tray that is used by the customer must be set up in the tray master le.
Each tray must be set with the following parameters :
*Height, Width and Length of the tray.
*Tray description (to make it user friendly)
*Tray and lm weight (Tare values)
If the volume of the product is higher than 50mm (2.0 inches) you need to set VOLUME to 3:HIGH. When you set it to 3:HIGH, you get a pop up
message, press OK to accept it.
* There is no difference among 0:FLAT 1:LOW, 2:MIDDLE.
* When you put your hand in the machine during wrapping , press the EMERGENCY SWITCH, and press FILM REMOVE. Remove lm and release the
EMERGENCY SWICTH.
Tray programming
Tray programming

ISHIDA WM-NANO Specifications

General

Brand	ISHIDA
Model	WM-NANO
Category	Packaging equipment
Language	English