ISLAND HOPPER 10' Bounce N Splash User Manual

12
Anchoring
DO NOT USE IN STRONG WINDS OR STORMS.
STAY OFF WATER BOUNCER AND
PULL TO SHORE IF YOU EXPECT A STORM
IMPORTANT NOTE
•
IMPORTANT: You can anchor your bouncer using any of the anchor D-rings located
around the outside or inside (under) your water bouncer tube. We suggest you use
marine anchors or cinder blocks as anchors or you can connect to a secured bottom
mooring to tie o your water bouncer. Two ropes with 30 to 50 lb. anchors are
sucient in most conditions.
•
NOTE: Strong winds can drag anchors. Tie o to a runaway line that runs along
the lake bottom to a stake or dock on the shore.
Cleaning and Storage
1. Take Bounce N Splash out of the water when not in use. Lay out a clean tarp on
the ground and place the tube on top of the tarp.
2. Wipe down the tube with mild soap and water then dry the tube (DO NOT use
ARMORAL or any product that contains silicone or Petroleum Distillates) before
folding. Be sure the tube is DRY before folding.
3. Remove all the air from float tube using a shop vacuum or power inflator. WIPE DRY
to avoid mildew.
4. Wrap folded tube inside tarp and secure with rope or bungee.
5. Place the tube in the plastic container or carry bag.
6. Store product (tube, hardware and parts) in a cool, dry place (DO NOT store
directly on concrete). Place mothballs around stored inflatable to keep mice and
insects away.

ISLAND HOPPER 10' Bounce N Splash Specifications

General

Brand	ISLAND HOPPER
Model	10' Bounce N Splash
Category	Baby & Toddler Furniture
Language	English