Ispring WCFM500K User Manual

Troubleshooting
ISSUE POSSIBLE CAUSE POSSIBLE SOLUTION
The water conditioner
fails to regenerate.
Electrical service to the unit has
been interrupted.
Assure permanent electrical
service (check fuse, plug, pull
chain, or switch).
The timer is defective.
Replace timer.
Power failure.
Reset time of day.
Loss of water pressure.
Iron buildup in line to water
conditioner.
Clean line to water conditioner.
Iron buildup in water conditioner.
Clean control and add the
mineral cleaner to the mineral
bed. Increase frequency of
regeneration.
Inlet of control plugged due to
foreign material is broken loose
from pipes by recent work done on
the plumbing system.
Remove piston and clean control.
Loss of mineral through
drain line.
The air in the water system.
Assure that the well system has
proper air eliminator control.
Check for the dry well condition.
Improperly sized drain line flow
control.
Check for proper drain rate.
Iron in conditioned
water.
Fouled mineral bed.
Check backwash. Increase
frequency of regeneration.
Increase backwash time.
Control cycles
continuously.
Misadjusted, broken, or shorted
switch.
Determine if the switch or timer
is faulty and replace it, or replace
the complete power head.
The drain flows
continuously.
The valve is not programming
correctly.
Check timer program and
positioning of control. Replace
power head assembly if not
positioning correctly.
Foreign material in control.
Remove power head assembly
and inspect bore. Remove
foreign material and check
control in various regeneration
positions.
Internal control leak.
Replace seals and piston
assembly.
Page 9 www.123filter.com | (678) 261-7611 | support@123filter.com

Ispring WCFM500K Specifications

General

Brand	Ispring
Model	WCFM500K
Category	Water Filtration Systems
Language	English