Page 15
www.123filter.com | (678) 261-7611 | support@123filter.com
Programming the Central Water Filtration System
(1) Button Configuration
Key Pad Configuration
• MENU
This function is used to enter the basic setup information required at the time of installation.
• SET/REGEN
This function is used to initiate an immediate or delayed manual regeneration.
• DOWN/UP
These buttons are used to increase or decrease the value of the settings while in programming mode.
(2) Function Key Description
(a) "MENU"
Press and hold the key for 3 seconds to unlock the device while in standby mode.
Press and hold the key for 3 seconds in the unlocked state to enter the user menu settings, such as
regeneration mode, time, date, etc.
In the user menu display, press this button to immediately exit the menu display.
(b) "SET/REGEN"
While in the unlocked state, press and hold the button for 3 seconds to enter the manual
regeneration mode. You can choose either vacation mode or immediate regeneration. Choose
vacation mode and input estimated holiday days, the valve will regenerate in smart clean mode (see
p.17) when no water is used during the days; if there's water used during the days, the vacation
mode will be auto-off.
Delayed regeneration means that the system will start a regeneration at the next regeneration time
regardless of the remaining regeneration days or water consumption.
Press and release the button to
set a delayed regeneration that will occur at the regeneration time.
Immediate regeneration means that the system immediately starts a regeneration.
In the user menu display, press this button to once to delay regeneration.
To Next Page
Loading...
Need help?
General
