(2) Pre-heating Procedures
As an engine starting aid, pre-heating is required in a cold
engine starting.
I) Turn the starter switch key counter-clockwise to PRE-HEAT
position in order to heat the glow plugs on the engine.
The pre-heating time varies depending on the types of pre-
heating system as follows:
l
The type with an indication lamp
20 seconds are required until the indication lamp at the
instrument board goes off.
0 The type with a control resistance
25 to 30 seconds are required until the control resistance
coil red heats.
2) Turn the starter switch key clockwise to START position as soon
as the control resistance coil red heat or the indication lamp
goes off.
34
To Next Page
Loading...
Need help?
General
