ITech IT6512 Programming Guide

ADDRess
This command is used to set the slave machine’s address when communicating through
RS485 interface.If the value is 0,then all slave machines will deal with commands coming
from main machine.If the it is a nonzero value,then only the power supply with the same
address with main machine’s could deal with main machine’s commands.
Command syntax： ADDRess <NR1>
parameters：0-31
4.3 Relative information about display
DISPlay[WINDow][:STATe]
This command is used to turn on or turn off the VFD display board.When display board is in
off mode,then the output values will not be shown on the VFD screen.
Command syntax：DISPlay[:WINDow][:STATe] <bool>
Parameters： 0|1|ON|OFF
examples：DISPlay 1
inquiry syntax：DISPlay[WINDow][:STATe]?
Return parameters：0|1
DISPlay[WINDow]:TEXT[:DATA]
This command is used to display one message on the VFD display board.
Command syntax：DISPlay[:WINDow]:TEXT[:DTAT]<NR1><,text with quotation>
parameters：The first parameter represents the display position(0~47).The second parameter
is the characters to be displayed.
Inquiry syntax：DISPlay[WINDow]:TEXT[:DATA]?
Example: DISP:TEXT “1234”
DISPlay[WINDow]:TEXT:CLEar
This command is used to clear all information on the front panel.
Command syntax：DISPlay[:WINDow]:TEXT:CLEar
4.4 Trigger Commands
TRIGger[:IMMediate]
This command is used to create a trigger signal.It will give a trigger signal in BUS trigger

ITech IT6512 Specifications

General

Brand	ITech
Model	IT6512
Category	Power Supply
Language	English