JAC J2 User Manual



Maintenance Manual for J2 Sedan
Mechanical Part of Engine
127
■ Tightening
torque:
30-40N·m
⑦

Manually support the
tank
and c
arefully
lower the jack to dismount fuel tank.
Attention:
■ Make
sure
all
connections
have been
disconnected.
■
Make
sure
there
is
no
interference
with
vehicle.
2) Check after
dismantlement
①

Fuel
tank
■ Check for impurity of fuel. If any, clean
it
with
hot
water.
■
Capacit
y
of
fuel
tank:
45L
②

EV
AP
hose
and
clips
■ Check
the
hose
for
blockage,
corrugati
on, deformation and breakage.
■ Check
the
clips
for
damage
or
breakage.
③

Reinforced pla
te
and
its
backing
plate
■
Check
the
surface
of
reinforced plate
for
scratch
and
deformatio
n.
■ Check
the
backing
plate
for
crack, material loss, deformation and breakage.
3) Installation
Be aware of following precautions to install with steps contrary to dismantlement.
■
Firmly
hold
fuel supply hose
to
insert it.
■
Do
not
set
the
hose
clamp in expansion area
of
fuel pipe.
■
Please
refer to
“Fuel
Pipe
Joint”
for
precautions of
fuel pipe
joint
connection.
2.
Check
after
Installation
Check for leakage with following steps.
①

Set ignition switch at
“ON” position (when engine
stops), and then check
the connection of
fuel
pipeline fo
r leakage.
②
 Start the engine, increase its speed and recheck the connection between
piping and fuel
pipe of fuel
system for
leakage.
Fig. 1.4.017

JAC J2 Specifications

General

Brand	JAC
Model	J2
Category	Automobile
Language	English