GB-5
JACOBSEN AR3/TR3
TOPS FITTING INSTRUCTIONS
4 TOPS INSTALLATION
4.1 ASSEMBLY OF SEAT BELT KIT TO MILSCO
CE-200 SEAT.
Make sure that the machine is parked on flat
level ground, with the cutting units down in the
cutting position, with the parking brakes ON,
ignition OFF and the key removed from the
ignition.
Remove retaining screws & raise the seat
plate, secure with the seat stay.
Fully loosen the clamping bolt that is
assembled through the spacer on both sides
of the seat.
4.2 RH SIDE OF THE SEAT
Fit the plate on the RETRACTOR between the
spacer and the seat frame.
Securely tighten clamping bolt (25 - 35 Nm)
4.3 LH SIDE OF THE SEAT
Fit the plate on the BUCKLE between the
spacer and the seat frame.
Securely tighten clamping bolt (25 - 35 Nm)
Lower seat plate and refit retaining screws.
To Next Page
Loading...
Need help?
General
