GB-6
JACOBSEN AR3/TR3
TOPS FITTING INSTRUCTIONS
4.4 ASSEMBLY OF SEAT BELT KIT TO
MICHIGAN V-5300 SEAT.
Make sure that the machine is parked on flat
level ground, with the cutting units down in the
cutting position, with the parking brakes ON,
ignition OFF and the key removed from the
ignition.
Remove retaining screws & raise the seat
plate, secure with the seat stay.
4.5 RH SIDE OF SEAT
Fit the plate on the RETRACTOR against the
threaded boss on seat frame.
Fit Washer to Hex Head Screw, and screw
into threaded boss.
4.6 Securely tighten screw (25 - 35 Nm).
4 TOPS INSTALLATION
To Next Page
Loading...
Need help?
General
