49
J-400
= Language: Provides access to the language
programming, page 58.
= Units: Provides access for the temperature display in
Fº
or
Cº
, page 58. Default setting is
Fº
.
= Back Button: Tap to go back to the previous menu.
= Invert Button: Tap to invert the display image.
= Scroll Buttons: Scroll up and down to view the selections
available.
12.1 Programming the Heating Mode
Your Jacuzzi spa is equipped with 3 modes of
heating, Figure 12.1a. An automatic mode called
“Auto,” where the spa’s temperature is maintained
at all times. An energy saving heating cycle called
“Econo.” A mode that will only activate the heater
during the daytime called “Day” mode.
Note: The heater will activate when the
temperature drops 2° from the set temperature.
Indicates that the feature is active. Indicates that the feature is not
active.
From the Settings Menu, tap or to highlight the “Heat & Filter”
menu tab in Orange. Tap
Heat & Filter
to the enter the menu. Then select
one of the heating settings.
A. Auto heating:
1. When programmed to “Auto,” the spa will maintain the water
temperature to the set temperature. Heating will occur when
necessary.
2. To select this mode, tap next to the “Auto” icon.
B. Econo heating:
1. This is an energy saving heating program that allows the spa to heat
during non-peak hours. When programmed to “Econo,” the spa will
only be allowed to heat the water between 5:00 PM to 7:00 AM every
day of the week. The hours cannot be adjusted.
2. To select this mode, tap next to the “Econo” icon.
C. Day heating:
1. When programmed to “Day,” the spa will only be allowed to heat the
water between 7:00 AM to 5:00 PM every day of the week. The hours
cannot be adjusted.
2. To select this mode, tap next to the “Day” icon.
Auto
Econo
Day
Filter
2
1
Heat & Filter
Figure 12.1a
To Next Page
Loading...
Need help?
General
