7
INPUT CONNECTIONS
Use RCA audio cables to connect source units with preamp-level outputs to the amplifier; use the supplied bare wire-to-RCA adapters to connect to
source units that don’t have RCA output connectors.
Use a small Phillips screwdriver to loosen the adapter’s set screws and insert the speaker wires into the holes on the back of the adapter. Tighten
the set screws to secure the wires.
Always connect the (+) speaker wire to the (+) terminal on the adapter and the (–) speaker wire to the (–) terminal on the speaker.
IMPORTANT: Make sure the (+) and (–) bare wires do not touch each other. Touching wires can cause a short circuit that can damage the source
unit or the amplifier.
When you’re finished, plug the adapters into the input connectors on the amplifier.
• You can use either input connector to connect a source component with a single mono subwoofer output.
To Next Page
Loading...
Need help?
General
