Pg 13 JBL SA550 Classic Owner's Manual EN
Menu
Press the MENU button on the amplifier or the on the remote control.
Use the Input and Volume controls to navigate the menu, or use the navigation buttons on the remote
control.
Menu Tree
Display Select Display Brightness. Default is Full.
Balance Set left / right output balance.
Phones Ovr
Control whether the speaker outputs and pre-outs are muted when a pair of headphones are connected.
The default is Off (speakers muted). On = speakers unmuted.
Timeout Auto standby duration. Select Off to disable. Default is 20m.
BT Auto Sw Automatically select BT input when BT device starts playing. Default is On.
BT Volume Set maximum volume for BT Input. Default is 40.
PM Input Select input for fixed volume. Default is None.
PM Volume Set volume for fixed volume input. Default is 40.
Filter Select a digital input filter from the options. Default is Apodizing.
PLL (input)
Adjusts sensitivity to a digital source device’s clock. Normal is suitable for most sources. Select WIDE if noises or
audio interruptions occur (most likely from high jitter sources such as a TV or set-top box). Default is Normal.
System Code
Change the IR code set if the amplifier remote commands conflict with another device in your home. Changing this
setting does not affect the remote handset. Default is 16.
Version Displays the software version of the amplifier.
System Update Initiates a software update from the USB connector.
System Reset Restores factory settings.
BT Reset Restores factory settings to Bluetooth only – this will delete all stored pairing.
RS232 Stdby Enables RS232 operation when the amplifier is in standby. Default is Off.
To Next Page
Loading...
Need help?
General
