jcb 100 C-1 User Manual

15 - Engine
21 - Oil Filter
00 - General
15 - 91 9813/2700-2 15 - 91
Figure 165.
J
G
K
G Element holder cap
J Element
K Seal
6. Remove and replace the seals.
7. Apply clean oil on the seals.
8. Put the element on the cap.
9. Install the cap on the oil filter support.
10. Tighten the cap to the correct torque value.
11. Install the pipes on the support.
12. Secure the pipes with the clamps.
13. Through one of the filler points, fill the engine with
the recommended oil to the MAX mark on the
dipstick.
Figure 166.
L
L Oil filler caps
14. Wipe off any spilt oil, install the filler cap and
make sure it is secure.
15. Operate the engine, until the oil pressure low
warning light has extinguished.
16. Check for oil leakage.
17. When the oil has cooled, check the oil level
again, and if necessary top up with clean engine
oil.
Table 53. Torque Values
Item Nm
B 35
G 25

jcb 100 C-1 Specifications

General

Brand	jcb
Model	100 C-1
Category	Excavators
Language	English