jcb 100 C-1 User Manual

15 - Engine
27 - Crankcase Ventilation Filter
03 - Separator
15 - 103 9813/2700-2 15 - 103
03 - Separator
Remove and Install
Oil
Oil is toxic. If you swallow any oil, do not induce
vomiting, seek medical advice. Used engine oil
contains harmful contaminants which can cause skin
cancer. Do not handle used engine oil more than
necessary. Always use barrier cream or wear gloves
to prevent skin contact. Wash skin contaminated with
oil thoroughly in warm soapy water. Do not use petrol,
diesel fuel or paraffin to clean your skin.
Before removal
1. Make the machine safe with the lift arm lowered.
2. Make sure that the engine is safe to work on. If
the engine has been running, let it cool before
you start the service work.
3. Get access to the engine.
4. Remove the crankcase ventilation filter
Refer to: Engine > Crankcase Ventilation Filter
(Page 15-97).
Remove
1. Remove all the pipes from the separator.
Figure 171.
E
F
A
E
G
D
A Separator
D Crankcase
E Clamp
F Pipe
G Pipe1
2. Remove the screws.
Figure 172.
A
C
B
A Separator
B Screw
C Gasket
3. Remove the separator with the gasket.
Install
1. Check that the contact surfaces are free from
impurities.
2. Always examine the condition of the pipes, and
replace them if there is any doubt regarding the
integrity of their seal.
3. Always replace the gasket after each assembly.
4. Install the gasket on the separator.
Figure 173.
A
D
C
B
A Separator
B Screw
C Gasket
D Crankcase
5. Attach the holder on the crankcase with the
screws.
6. Tighten the screws to the correct torque value.

jcb 100 C-1 Specifications

General

Brand	jcb
Model	100 C-1
Category	Excavators
Language	English