jcb 205T Service Manual

15 - Engine
12 - Crankshaft
00 - General
15 - 55 9813/9750-1 15 - 55
Calibrate
Axial clearance check
1. To measure the axial clearance of the crankshaft,
it is necessary to assemble the shaft in the
crankcase.
2. Measure the axial shift of the crankshaft with a
dial gauge. The axial shift must range between
0.18-0.38mm (0.007-0.015in).
3. If the value is more than or less than the specified
range, replace the shoulder rings.
Figure 142.
A
B
A Crankshaft B Dial gauge

jcb 205T Specifications

General

Brand	jcb
Model	205T
Category	Front End Loaders
Language	English