About the Product
Product and Component Identification
9 9831/3950-1 9
Product and Component Identification
Machine
The machine identification plate is located inside the cab on the seat base. Refer to Figure 7.
The identification plate is a tamper-proof decal. Do not attempt to modify it in any way.
The identification plate lists the machine's unique VIN (Vehicle Identification Number), serial numbers of main
driveline components and the permissible vehicle loads.
Figure 7.
e11* XXXX/XX* XXXXe11* XXXX/XX* XXXX
E
13000kg
A-1 : 6500kg
A-2 : 7500kg
JCB43X60EH2185000
Table 1.
A Identification plate (location)
B ECC number
C VIN number
D Total permissible mass
E Axle permissible load. A-1 = Front axle, A-2 = Rear axle
F Braking system. B-1 = Un- braked towable mass, B-2 = Independent braked tow-
able mass, B-3 = Semi or continuous braked mass, B-4 = Power braked towable
mass
G Trailer type. T-1 = Drawbar, T-2 = Rigid drawbar, T-3 = Centre-axle
Table 2.
Tractor type P148XXXX. Varies depending on territory and speed.
EC number Conformity certification number
Typical Product Identification Number
This includes the machine's unique serial number and original build specification. This identification number
is also stamped into the chassis.
Table 3. Typical PIN
JCB 43 X 60 E H 2185000
Table 4. Explanation of the PIN
Digit Description
1 to 3 World Manufacturer Identification. For example, JCB = UK Build.
4 to 5 Engine Type: 41= 6.6L118kW, 42= 6.6L141kW, 43= 6.6L163kW
6 Transmission Type: X= 4190/4220 CVT. SD55/SD88 axles, Y= 4160 CVT. SD55/SD70 axles
7 to 8 Vehicle Maximum Speed (according to territory)
9 Check Letter. A randomly generated letter to verify authenticity of the PIN (Product Identifica-
tion Number)
To Next Page
Loading...
Need help?
General
