48Z-1, 51R-1, 55Z-1, 57C-1 21
Troubleshooting/FAQs
Issue / FAQ Resolution/Answer
My machine will not start
Ensure the start up sequence has been followed (Page 11).
Immobiliser pin from factory is 1945
.
If machine still will not start contact dealer
I can’t activate the Hydraulics
There are many reasons as to why your 2Go may not work when pressing the
button on the switch panel. Here are some of the possible reasons:
• If the left hand pod is lifted and put back down when machine hydraulics are
“on”, machine hydraulics will disable and not function again until side pod
down and machine in neutral.
• The left hand pod is in the raised position
• There is a fault on the keypad
• Engine isn’t switched on
• If there is an error on the machine and an error code is displayed on the LCD
screen – which would inhibit the hydraulics
• If none of the above, contact dealer
Can I open the Quick Hitch with the
attachment on the ground?
The Quick Hitch can be opened with the attachment on the ground. Follow the
instructions previously (Page 13) and at step 4 follow 4a-4b
Why is there an audible buzzer in the cab
when I’m lifting a large load?
The lift overload warning system has detected a load that is near the limits of
the machine, reduce load to prevent machine overturn
Can I disable the lift overload warning
indicator when not object handling?
To disable lift overload warning indicator when not object handling press button
no 4 on switch panel
To Next Page
Loading...
Need help?
General
