06 - Body and Framework
24 - Slew Ring
00 - General
06 - 25 9813/5300-1 06 - 25
E Hoses
14. Remove the bolts 1.
15. Remove the slew base from the chassis with
suitable lifting equipment.
Figure 20.
F Bolts 1
16. Support the slew base with the blocks.
17. Remove the bolts 2.
18. Remove the slew ring from the chassis with
suitable lifting equipment.
Figure 21.
G Bolts 2
19. Collect the shims and make a note of their
locations to help installation.
Install
1. The installation procedure is the opposite of the
removal procedure. Additionally do the following
steps.
2. If necessary, do the shimming procedure. Refer
to (PIL 06-24).
3. Tighten the bolts to the correct torque value.
4. Bleed the hydraulic system. Refer to (PIL 30-00).
Table 3. Torque Values
Item Description Nm
F Bolts 1 230
G Bolts 2 230
To Next Page
Loading...
Need help?
General
