D
3. CHANGING A SAW
BLADE (See A)
Press the spindle lock button (18),
and use the spanner (21) provided
to remove the blade bolt (22) and
outer flange (23). Rotate lower blade
guard (13) clockwise and hold
open using the lower blade guard
lever (14) whilst changing the saw
blade (12). Ensure the blade bore
is located on the inner flange (24)
and the blade direction arrow points
in the same direction as the lower
blade guard (13) arrow. Check the
blade surface and flanges are clean.
Depress the spindle lock (18) again
and re-fit the outer flange (23) over
spindle (25), and tighten bolt 1/4
turn more than finger tight. Check
the blade is securely clamped.
Warning: blade teeth are very sharp
and wear gloves. For best cutting
results ensure you use a saw blade
suited to the material and cut quality
you need.
4. DEPTH OF CUT
ADJUSTMENT
Lift the depth of cut Adjustment
lever (20) and raise the saw body
away from the base plate (15). Set
the depth of cut using the scale (19)
and push the lever (21) down to lock
(See D). Always add 3mm to your
depth of cut so the blade can cut
through the material.
To Next Page
Loading...
Need help?
General
