WORKING HINTS FOR
YOUR CIRCULAR SAW
If your power tool becomes too hot,
run no load for 2-3 minutes to cool
the motor. Avoid prolonged usage at
very low speeds. Always use a blade
suited to the material and material
thickness to be cut. The quality of
cut will improve as the number of
blade teeth increases. Always ensure
that the work-piece is firmly held
or clamped to prevent movement.
Support large panels close to the cut
line. Any movement of the material
may affect the quality of the cut. The
blade cuts on the upward stroke and
may chip the uppermost surface
or edges of your work piece. When
cutting, ensure your uppermost
surface is a non- visible surface
when your work is finished.
POCKET CUTTING (SOFT
MATERIALS ONLY)
This operation requires skill and
caution and must only be carried
by a competent person.
WARNING
: The blade teeth
are exposed during this
operation so proceed with
extreme caution.
Clearly mark the area to be cut. Set
the depth of cut on the saw. Position
the saw over the marked area with
the front edge of the base plate
resting on the work surface and
cutting guide aligned with marked line
To Next Page
Loading...
Need help?
General
