jcb JCB-CS38 User Manual

SL7 1TB
Customer Helpline 0845 600 5526 Monday to Friday 09.00 to 17.00
www.JCBdiy.com
PROBLEM SOLVING
If these solutions do not solve the problem, contact your authorised service dealer.
PROBLEM POSSIBLE CAUSE SOLUTION
Engine will not start. No spark.

Clean or replace spark plug.
 Reset spark plug gap.
Engine is flooded.
 With the ignition switch Off,
remove spark plug.
 Move choke lever to “Run”
position (pushed in completely)
and pull starter grip 15 to 20
times. This will clear excess fuel
from engine.
 Clean and reinstall spark plug.
 Set ignition switch to “Run” ( l )
position.
 Push and fully release primer
bulb 10 times.
 Pull starter grip three times with
choke lever at
“Run” position.
 If engine does not start, move
choke lever to
“Full choke”
position and repeat normal
starting procedure.
 If engine still fails to start,
repeat procedure with a new
spark plug.
Engine starts but
will not accelerate
properly.
Carburettor requires
“L”
(Low jet) adjustment.
Contact an authorised service
centre for carburettor adjustment.
Engine starts, then
dies.
Carburettor requires
“L”
(Low jet) adjustment.
Contact an authorised service
centre for carburettor adjustment.
Engine starts but
will not run properly
at high speed.
Carburettor requires
“H”
(High jet) adjustment.
Contact an authorised service
centre for carburettor adjustment.
JCB-CS38_960488008-01_Manual_final_ OEM licence.indd 35JCB-CS38_960488008-01_Manual_final_ OEM licence.indd 35 12/3/2010 5:58:49 PM12/3/2010 5:58:49 PM

jcb JCB-CS38 Specifications

General

Brand	jcb
Model	JCB-CS38
Category	Chainsaw
Language	English