JCB-E460P
Instruction & User Manual
20
Maintenance - Oil Servicing
When changing a machines oil, run the machine for a few minutes. Warm oil will always drain faster and more
through compared to oil that’s cold.
> Place a suitable container below the engine to catch the used oil.
> Remove the oil filler cap/dipstick, oil drain plug and washer.
> Allow the used oil to drain completely
> Reinstall the oil drain plug and new washer, and tighten the oil drain plug securely. Please dispose of used motor
oil in a manner that is compatible with the environment. We suggest you take used oil in a sealed container to
your local recycling centre or service station for reclamation. Do not throw it in the General Waste, pour it on
the ground, or down a drain.
> 3. With the engine in a level position, fill to the upper limit mark (bottom edge of the oil fill hole) on the dipstick
with the recommended oil.
Oil Filler Cap
/Dipstick
Drain Plug & Washer
Oil Grade
Use 4-stroke motor oil that meets or exceeds
the requirements for API service classification
SJ, SL, or equivalent. Always check the API
service label on the oil container to be sure it
includes the letters SJ, SL, or equivalent. SAE
15W-40 is recommended for general use.
Other viscosities shown in the chart may be
used when the average temperature in your
area is within the indicated range.
Oil Lever
To Next Page
Loading...
Need help?
General
