Sawdust bag (Fig. 1)
The saw is equipped with a sawdust bag (17)
for sawdust and chips.
Squeeze together the metal ring on the dust
bag and attach it to the outlet opening in the
motor area.
The sawdust bag (17) can be emptied by means
means of a zipper at the bottom.
Changing the saw blade (Fig. 14/15/16/17)
Remove the power plug!
Important.
Wear safety gloves when changing the
saw blade. Risk of injury!
• Swing up the machine head (4).
• Undo the screw (e) on the guide bar (37),
so that it can move freely and be pivoted
downwards.
• Press the release button (3). Swing up the
saw blade guard (5) to the point where the
recess in the saw blade guard (5) is above
the flange bolt (29/30/31).
• Press the saw machine head (4) with one
hand. With the other hand insert the allen
key (d) in the flange bolt (29/30/31).
• Hold the Allen key (d) and slowly close the
saw blade guard until it touches the Allen
key.
• Firmly press the saw shaft lock (31) and
slowly rotate the saw shaft lock (31) in
clockwise direction. The saw shaft lock (31)
engages after no more than one rotation.
• Now, using a little more force, slacken the
saw shaft lock (31) in the clockwise direction.
• Turn the saw shaft lock (31) right out and
remove the inner flange (32).
• Take the blade (6) off the inner flange (32)
and pull out downwards.
• Carefully clean the flange screw (31), outer
flange (30) and inner flange (32).
d
31
Fig.14
Fig.15
Fig.16
Fig.17
29
30
e
37
5
31 306
23
JCB-MS-210SB
Instruction & User Manual
To Next Page
Loading...
Need help?
General
